What’s
an LED?
Function
LEDs emit light when an electric current passes through them.
Connecting and soldering
LEDs must be connected the correct way round, the diagram may be labelled a or + for anode and k or - for cathode (yes, it really is k, not c, for cathode!). The cathode is the short lead and there may be a slight flat on the body of round LEDs. If you can see inside the LED the cathode is the larger electrode (but this is not an official identification method).
LEDs can be damaged by heat when soldering, but the risk is small
unless you are very slow. No special precautions are needed for soldering
most LEDs.
Testing an LED
Never connect an LED directly to a battery or power supply!
It will be destroyed almost instantly because too much current will
pass through and burn it out.
LEDs must have a resistor in series to limit the current to a safe value, for quick testing purposes a 1k resistor is suitable for most LEDs if your supply voltage is 12V or less. Remember to connect the LED the correct way round!
For an accurate value please see Calculating an LED resistor value below.
